Self-host

Self-host settings

On self-host you run the whole machine, so you decide how often things happen and how much runs at once. The settings apply to every playlist on your install. Follow these steps to open them and change what you need.

Steps

  1. Open Settings: Click Settings at the bottom of the left rail. This button is only there on self-host.
  2. Change a setting: Pick a new value from the list next to it, or click a number. Every change saves by itself and a Saved message shows. Only the TMDB key has a Save button.

The settings are grouped as below. The default is the value a new install starts with.

Messages

Open Messages in the Settings menu to pick where M3UTool tells you things. Each message has a tick for Discord and one for Email: tick one, both or none. It saves by itself. M3UTool sends these messages for your box, so they also come when the box is off.

Click Send a test to check that both arrive. Discord messages go to the Discord account you connected on editor.dontv.shop, emails to your M3UTool email.

Refresh and checks

Note: The settings of each playlist's sources still decide which sources refresh at all. These settings only set how often. More in Auto refresh.

Work in parallel

Higher numbers finish sooner, but use more of your computer and more of your provider connections. If your provider allows only a few connections, keep Checks at once low.

TV guide

Backups

More in Backups and restore.

Advanced

Click Advanced to open this group. Leave these as they are unless you have a reason.

Your account on self-host

Open Account at the bottom of the left rail to see the account self-host uses.

Pictures show made-up demo channels and Blender open movies (© Blender Foundation, CC BY).